A licensed HVAC pro who works in 63104 will call you back — free.
Service area: The Soulard triangle in 63104, bounded by I-55 on the west and north and by 7th Street and Broadway on the southeast, from the market down to the brewery.
Three in four homes went up before 1940
Across the two census tracts covering central and southern Soulard, 2,964 of 3,993 housing units date to 1939 or earlier. Only about a quarter are freestanding houses; the rest are attached rows, two-family flats and small walk-ups. (Census ACS 2020–2024)
Rooftop units can't face the street
Soulard's historic district standards say a rooftop air conditioner must not be visible from the front street or visually dominant from any other street. (Soulard Restoration Group)
1
Tell us what's wrong
Name, phone, and a line about the heat or the AC. It takes about a minute.
2
One local pro rings you
We send your request to a single independent licensed contractor who covers Soulard. You choose whether to book.
Soulard is one of the oldest corners of St. Louis: Antoine Soulard arrived in 1794, the City bought the land in 1841, and immigrant families filled it with brick row and "half" houses (City of St. Louis). Those buildings, and the district rules that protect them, shape every heating and cooling job here.
Half houses, flats and 19th-century brick
Early Soulard homes were Greek Revival farmhouses and modest row houses; after 1850 they grew more ornate, and larger mansions followed the Civil War. A tornado in 1896 flattened the market and many nearby buildings, and the current market hall dates from 1929 (City of St. Louis). Lynch Street splits the area: rows and small apartments to the north, the Anheuser-Busch brewery to the south (Wikipedia).
Census tracts 1233 and 1276 (central and southern Soulard), ACS 2020–2024 estimates
Measure
Count
Share
Units built 1939 or earlier
2,964 of 3,993
74%
Attached single-family (row) houses
536
13%
Two-unit buildings
665
17%
Three- and four-unit buildings
1,060
27%
Freestanding single-family houses
954
24%
Occupied homes heated with utility gas
2,308 of 3,398
68%
Occupied homes heated with electricity
1,037
31%
Occupied homes that are rented
2,021
59%
What the Soulard standards say about equipment
Soulard is one of the City's certified local historic districts, so exterior work is checked against its own written standards (City of St. Louis). The parts that matter for heating and cooling, as summarized by the neighborhood's restoration group (Soulard Restoration Group):
Rooftop AC units must not be visible from the front street or visually dominant from any other street.
Roof piping and vents aren't regulated, though flues and vent stacks are recommended to stay off roof slopes facing a public façade.
Exterior electric meters should go in a gangway or on a private façade where possible, never on a foundation or public face. That matters if a heat pump means new electrical work.
Any other non-original item must stay out of view from a street unless it's based on a model example.
Unsure about a placement? The Cultural Resources Office answers questions on district standards at (314) 657-3865 (City of St. Louis).
Heating and cooling a house that shares its walls
Party walls hold heat. An attached row house loses less through its side walls than a detached one, so a replacement furnace sized off a rule of thumb can come in oversized. Ask for a load calculation.
Upper floors run hot. Central air in a 19th-century house was added much later, and supply runs to the top floor are often long and narrow. If the second story lags, ask the pro to check airflow before upsizing the condenser.
Back yards are small. With the roof restricted and gangways tight, condenser placement is often the hardest part of the job. Settle where it goes before you compare prices.
About three in ten homes heat with electricity (Census ACS). For those units a heat pump is a direct swap worth pricing.
The City permit for a Soulard job
Missouri doesn't license HVAC trades statewide; inside city limits the license and the permit both come from the City of St. Louis. A mechanical permit covers installing furnaces, boilers and ventilation, and the City issues it only to mechanical contractors it has licensed. Applications go through stlcitypermits.com or the walk-in counter in Room 425 of City Hall, carry a $25 application fee plus work fees, and are usually approved in one to three business days. The governing code is the 2018 International Mechanical Code under Ordinance 70800 (City of St. Louis). Ask your contractor for the permit number and inspection date.
Quick answers
Can a new condenser go on the roof of my Soulard row house?
Only if it can't be seen from the street in front, and it can't dominate the view from any other street. The standards define "visually dominant" as filling more than 10% of a building's visual plane from a street. Many owners put equipment in the rear yard instead. (Soulard Restoration Group)
Who signs off on the mechanical work, the City or the neighborhood?
Two different offices. The City Building Division issues the mechanical permit, and only to contractors holding a City of St. Louis mechanical license. Exterior changes in a local historic district such as Soulard are reviewed by the Cultural Resources Office against the district's standards. (City of St. Louis permits; City historic districts)
We have two flats in one building. Do both units share a furnace?
Often not. Two-family buildings in Soulard frequently have one system per flat, so the upper and lower units can fail on different schedules. Tell the pro which unit you're in and where its equipment sits, since a basement furnace may serve only the downstairs.
Does a Soulard address get any utility help on new equipment?
Electric service here is Ameren Missouri and gas is Spire. Look at Ameren's efficiency programs page for current offers before you sign a bid.
What do I owe TrueLocalPro?
Nothing. We are a free referral service and don't do repairs. The contractor who calls is independent, and you'd pay them only if you hire them.
Sources
Facts on this page were checked against these sources on 2026-11-07. Prices and rebates change — confirm current details with the source or your contractor.