Almost nothing here is younger than 1940
In census tract 1243, which lines up closely with Benton Park, 1,646 of 1,913 housing units were built in 1939 or earlier, and none are counted from 2010 onward. (Census ACS 2020–2024)
A licensed HVAC pro who works in 63118 and 63104 will call you back — free.
Service area: Benton Park in south St. Louis, from Gravois Avenue down to Cherokee Street and from Jefferson Avenue east to I-55.
In census tract 1243, which lines up closely with Benton Park, 1,646 of 1,913 housing units were built in 1939 or earlier, and none are counted from 2010 onward. (Census ACS 2020–2024)
District standards require existing chimneys to be kept. One that no longer vents anything may be capped, but its height and size can't change. (Benton Park standards)
Your name, a phone number or email, and the problem that fits best. If the house is a row or a flat, say so.
We route the request to a single independent HVAC company working in this part of south city. There's no charge and no commitment to hire.
Benton Park covers just under half a square mile south of Gravois and had 3,581 residents in 2020 (Wikipedia). Its houses sit over a web of caves that once chilled lager for the Lemp brewery, and many of the buildings still standing date from the 1880s and 1890s.
The park itself began as the City Cemetery; once the graves were moved, an ordinance of June 25, 1866 created City Park, later renamed for Thomas Hart Benton. Homes followed soon after the Civil War, and by 1875 small and medium single-family houses stood on firm ground between sinkholes and underground caverns (City of St. Louis). The caves held a steady 55°F, which is why breweries settled here; their entrances are all sealed now (Wikipedia).
Benton Park went on the National Register in 1985 and became a City historic district in 2006 under Ordinance 67175 (City of St. Louis).
With roughly one row house in five and about a quarter of homes on electric heat, a typical week of service calls here mixes gas furnaces in basements with air handlers and heat pumps in tight attached houses.
| Measure | Count | Share |
|---|---|---|
| Units built 1939 or earlier | 1,646 of 1,913 | 86% |
| Freestanding single-family houses | 932 | 49% |
| Attached (row) houses | 356 | 19% |
| Units in 2- to 4-unit buildings | 336 | 18% |
| Occupied homes heated with utility gas | 1,149 of 1,579 | 73% |
| Occupied homes heated with electricity | 418 | 26% |
| Owner-occupied homes | 982 | 62% |
The Benton Park standards grade every wall of a building, and that grading decides where outdoor HVAC gear can go (Benton Park standards):
A furnace, boiler or ventilation install in Benton Park needs a mechanical permit from the City Building Division, which issues them only to contractors holding a City mechanical license. The fee is $25 per application plus work charges, the code is the 2018 International Mechanical Code (Ordinance 70800), and most permits are approved within one to three business days (City of St. Louis). Historic review of exterior changes is a separate step handled by the Cultural Resources Office.
It stays. Benton Park's standards say existing chimneys must be retained; an unused one may be capped, but it can't be shortened or otherwise changed in dimension. The standards also recommend keeping metal flues and vent stacks off any roof slope that faces a Public Facade. (Benton Park standards)
Check how that wall is classed first. A side wall that faces a vacant lot or a side yard at least 15 feet wide, and is visually dominant from the street, counts as a Semi Public Facade under the district standards, so equipment there is more visible than in a rear yard or gangway. The Cultural Resources Office, (314) 657-3865, can tell you how your lot is treated. (Benton Park standards; City historic districts)
No. There's no state HVAC license in Missouri to fall back on, and the City of St. Louis grants mechanical permits only to contractors that hold its own license. A county-only firm would need the City license before pulling a permit for your furnace or boiler. (City of St. Louis)
Possibly, but they change. Ameren Missouri supplies electricity and Spire supplies gas; look at Ameren's efficiency programs and Spire's rebates page for what's open before you sign.
Nothing. TrueLocalPro passes your request along for free and does no repair work itself. The pro who calls runs an independent business, and any bill is between you and them.
Facts on this page were checked against these sources on 2026-11-07. Prices and rebates change — confirm current details with the source or your contractor.