A licensed HVAC pro who works in 63139, 63110 and 63117 will call you back — free.
Service area: Dogtown south of Forest Park, from Oakland Avenue down to Manchester and from Macklind west to McCausland and the city limit, taking in Clayton-Tamm, Franz Park, Hi-Pointe and Cheltenham.
Wood siding is common here, which is rare in old St. Louis
Large wood-framed, sided homes are described as unusual for St. Louis yet prevalent in Franz Park, alongside small post-war frame houses, brick, Dutch Colonials and stone (NextSTL). A frame wall leaks and insulates differently from triple brick, so heat-loss math should be done for your actual house, not a typical city bungalow.
Hi-Pointe ends at the city limit
Richmond Heights, in St. Louis County, starts at Hi-Pointe's western edge (City of St. Louis), and the two share the 63117 ZIP. A house on the city side needs a City-licensed mechanical contractor.
1
Tell us what's wrong
Pick the problem, add a phone number or an email, and note whether the house is brick or frame if you know.
2
One Dogtown-area pro gets in touch
We send your request to a single independent licensed contractor. There's no auction of your details and no duty to book.
Dogtown is a nickname, not one of the City's official neighborhoods. It stretches across Clayton-Tamm, Franz Park, Hi-Pointe, Cheltenham and part of Ellendale, from Oakland Avenue south to Manchester (Wikipedia). About 8,000 people lived in those first four neighborhoods in 2020 (City of St. Louis census data).
Built around clay pits, then over them
Building in Clayton-Tamm began in 1852, when the Pacific Railroad reached Cheltenham. Fire-brick makers came for the clay, and Irish, Italian, German and Polish miners put up housing beside the pits. As the mines shut, subdivisions went up on the old sites; nearly all were closed by the end of World War II (City of St. Louis).
That stop-start growth is why one block can hold an 1890s farmhouse, a 1920s brick bungalow and a 1950s frame cottage. Each was built for a different heating plant, from coal stove to gravity furnace to forced air, and many still carry traces of the older setup: oversized ducts, capped chimneys, a register in an odd place.
Three census tracts, three different housing mixes
The ZIP codes here also cover neighborhoods far from Dogtown, so these figures use the three census tracts that hold most of it. Franz Park's tract is almost all freestanding houses on gas; the tract around Clayton and Tamm has the apartment buildings, and a lot more electric heat.
ACS 2020–2024 five-year estimates, U.S. Census Bureau via Census Reporter
Census tract (area)
Housing units
Built before 1940
Single-family detached
Occupied homes on gas / electric heat
1268 (Franz Park)
1,735
1,058
1,435
1,277 / 253
1042 (Wade Ave to Hi-Pointe)
2,036
970
1,099
1,424 / 314
1045 (Clayton & Tamm)
1,774
619
671
727 / 617
High ground and older frame walls
Hi-Pointe takes its name from being one of the highest elevations in the city (City of St. Louis), and the Dogtown neighborhoods as a whole are surprisingly hilly (NextSTL). Houses on a rise with sided walls catch more winter wind than a brick row tucked into a flat block.
If the north rooms never warm up, ask for a heat-loss calculation and an air-sealing check before anyone suggests a bigger furnace. Bigger equipment in a leaky house tends to short-cycle and still leave cold corners.
Who signs off on the job
City of St. Louis Building Division. Furnaces, boilers and ventilation systems need a mechanical permit, and only City-licensed mechanical contractors may apply. Most are approved in one to three business days. The Permit Section is at 1200 Market, Room 425, (314) 622-3313 (City of St. Louis).
No historic-district review here. None of Dogtown's neighborhoods is among the City's local historic districts, so exterior equipment doesn't go to the Cultural Resources Office as it would in nearby Skinker-DeBaliviere (City of St. Louis).
Not the county. Missouri doesn't license HVAC contractors statewide, and a St. Louis County license doesn't carry over to a city address. Ask any company for its City license number.
Gas, power and a winter safety net
Spire, the former Laclede Gas, supplies the gas most Dogtown furnaces burn, and Ameren Missouri supplies the electricity; check Ameren's efficiency programs for anything currently on offer. Between November 1 and March 31, regulated gas and electric utilities can't shut off heat for nonpayment when temperatures are forecast below 32 degrees within 72 hours; the PSC hotline is 1-800-392-4211 (KBIA).
Quick answers
My address says 63117. Does a City contractor still have to do the work?
If the house sits inside the city limit, yes. That ZIP straddles Hi-Pointe and Richmond Heights, so the mailing code alone doesn't tell you. Only contractors licensed by the City of St. Louis can pull a City mechanical permit (City of St. Louis).
Will the Cultural Resources Office need to approve a new condenser in my side yard?
Clayton-Tamm, Franz Park, Hi-Pointe and Cheltenham don't appear on the City's list of 18 local historic districts, whose exterior changes go through that office (City of St. Louis). The mechanical permit still applies.
I rent in one of the apartment buildings near Clayton and Tamm and the heat is electric. Who do I call?
Your landlord first, in writing. In the census tract around Clayton and Tamm, over half the housing units are in buildings of five or more, and electric heat is nearly as common as gas, so many renters there have an air handler the owner maintains.
We're tearing down a small post-war house to build new. Can you help with that?
We handle repair and replacement requests for existing homes. For new construction, your builder normally picks the mechanical contractor, who still needs a City license and permit.
Do I pay TrueLocalPro anything?
No. We are a free referral service and don't do HVAC work ourselves. Any price is between you and the independent contractor who calls.
Sources
Facts on this page were checked against these sources on 2026-11-07. Prices and rebates change — confirm current details with the source or your contractor.